cchange print from verticle to horizontal

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

Bob G - 31 Oct 2003 17:51 GMT

I would like to print a table that is 11" wide by 8 1/2"
long. I am set up for paper that is in the tray at 8 1/2".
I am sure there is a way to change the file to move from 8
1/2 etc.

Reply to this Message

bob - 31 Oct 2003 18:01 GMT

>-----Original Message-----
>I would like to print a table that is 11" wide by 8 1/2"
>long. I am set up for paper that is in the tray at 8 1/2".
>I am sure there is a way to change the file to move from 8
>1/2 etc.
>.

Reply to this Message

Richard G. Harper - 01 Nov 2003 00:36 GMT

Print it in landscape mode. You should be able to do so (depending on the
software you're using, since you didn't bother to mention that essential
fact) in File/Print Setup.

Signature

Richard G. Harper (rgharper@email.com) MVP Win9x
* Please post all messages and replies in the newsgroup so that
* all may benefit. Private mail is usually not replied to.
* Help US Help YOU ... http://www.dts-l.org/goodpost.htm

> I would like to print a table that is 11" wide by 8 1/2"
> long. I am set up for paper that is in the tray at 8 1/2".
> I am sure there is a way to change the file to move from 8
> 1/2 etc.

Reply to this Message