i'm attempting to install win95b (from scratch) on an old pentium pc with
scsi devices (toshiba xm 5401 ta cd-rom & a seagate st3255on hard
disk)...can't seem to load cd-rom drivers when booting off floppy.
the bios is phoenix & ncrpci 3.05.03 (ncr sdm v3.0 pci scsi bios rev2).

I want Netsetup.exe which is only there in Windows 95
Retail Version under Admin\Nettools\Netsetup folder Can
any one help me for the same. Please I need these file
urgently. Problem with me is the Windows 95 Retail Version

at the begining of the installation "after scandisk " the following message
displayed  
"can not decompres *.cab files "

i have an old computer 80486 ,it was installed win3.11 on it and i want to
replace by win95
what want to know if the computer will work?

when I boot up this computer, and and its memory is so full that as far as it
gets is to tell me that everything is running and I can now turn off the
computer..
  ok, how does one go about getting in their to reformat and put in a fresh

I have a machine with Windows 95.  Lately when I turn it on, it says "write
protect error" "writing drive C, abort, retry, fail"  Does anyone know what
is going on with it and can it be fixed?

Hi, i have a few computers (win 98 and 95) that are networked in a workgroup
network. When the computers start up, they read a bat file from the server
that deletes temp files, directories etc.
I managed to get the 98 computers reading the BAT file at stratup via the

Is it still possible to purchase Windows 95 or download it from a website?

Please help me to setup networking in a Win95 PC. I am trying to
connect a PC with Win95 (SP1) into a peer-to-peer network in order to
share files/printers and internet. But I cannot get this to work.
My current network consists of these devices:

"error in Config.sys file on Line 5"
line 5 reads<DEVICEHIGH=C:\CDROM\ATAPI_CD.Sys/D:CDIDE001>
what should it read?