I reformatted my computer and am trying to reinstall
windows 98 but it tells me that it is an invalid system
disk. What should I do???

I have errors on partition I:.  (all drives (except I:)
work fine in defrag.)  When I attempt to run scanDisk, I
immediately recieve the error messege: "ScanDisk - (C:)
ScanDisk cannot check this drive now because the drive is

Is there any way under windows 98 to find and restore
permenently deleted files? Anything like the old undelete
command of ms-dos? I have some jpeg files that seem to
have gone missing somehow or another. I can only guess

   I uninstalled AdaptecCD system.  When I re-install
adaptec from original recovery disk, I get error
message "cannot install on this system"?
   Can anyone help with this?

Windows will crqash after inserting a disk in the CD-Rom
drive.  Any idea's  I have replaced the CD-Rom drive with a
different drive and I had the same results.

WHERE CAN I PURCHASE A REPLACEMENT 98SE CD?

I must try other spyware?
There is a method to avoid all the banners??
Thx

My Compaq Presario runs on Windows 98. This computer has
been out of function for sometime now. Thus, when I switch
it on, the following message would appear on the monitor "
Operating system can not be found on any device".

I have a 10 gig western digital drive and its everthing is
on c drive now.  I would like to create extended dos
partition and additional logical drive for other use. What
is the correct procedure for this and can I do it while

I receive an error message when I try to defrag my c drive.
Windows cannot defragment this drive now because it has
been locked by a disk utility. Quit any utilities that may
have locked this drive, and then try defragmenting the

I have saved two years worth of quarterly reports on my
disk.  Today, when I started to work with that disk, I get
a message that says:  cannot be accessed.  The file may be
read-only or you may be trying to access a read-only

When I run defrag it gives me the message "drives contents
changed starting over".  I ran scandisk and that doesn't
help.  It only defrags to 10%.  

My current 2940UW controller BIOS startup screen shows:
Adaptec AHA-2940 BIOS v1.16
on bootup.
I have the upgrade file for:  AHA-2940UW - BIOS 2.20.0 but I haven't

Does anyone know if there is a file size limit with WIN
98SE, FAT 32, 20Gig Drive.  I am doing some video work and
can't seem to generate files much over 4 gig in size.

WIN98 setup progam is run to install WIN95/WIN98,
the following error message will occur
  ATTENTION: A serious disk error has
  occurred while writing to drive C.