I' m trying to run scandisk to the C drive it gets to
about 30% and stops with an error 53, the machine hangs
and I need to POR.
Can anyone help

  I would like to format my computer and when i type in
Format c: i then press the "Y" Key to proceed i get the
following error "Insufficient Memory"
Can someone please help me?

How does one go about getting Windows 98 reloaded on a PC
if we cannot find the original disks are and the PC's
Windows 98 has crashed?  Thanks for any help you can
provide.

Please help me on this one...
Everytime I try to format my hard drive using the Win98
startup disk...I do a  FDISK first but can't get the FDISK
to work and get the following message:  "no fixed disks

While attempt to re-upgrade my window 98 2nd edition to
window 95, the above message showed up.  Not sure if it is
a problem of my hard drive or a problem with my cd-rom
disk.

somehow my 2nd HD wasn't recognized anymore by win98. There wasn't anything
important on it so i repartitioned and reformated. Everything went fine and
win98 recognized the drive again. However, after a while (5-10 min) a few
letters in the label of the drive changed. I bit later ...

I have an installation disk on CD for a print shop
program.  This was installed on my PC at home.  When I
tried to install it on my computer at work, the CD appears
as an audio CD.  I tried another one that had been made

This is the 3rd time this problem has plagued me.  It has
happended twice on a previous machine and has just
happened again on a different one! Basically after booting
from a floppy disk and then restarting to boot from the

My defrag program opens but stays at 0% and never looks
like its running. If there a way to reinstall it?

I had to replace a bad hard drive which was 4gb.  The new
drive is 40gb.  I ran fdisk and enabled it for large
drives and did not partition the drive but when I
installed Windows 98 it only recognizes 4gb the original

Recently I  migrated my CDRom (Teac) from my P1-200 to P1-
133, both running on Win98SE. With previous P1-200, I have
no problem on booting from CDRom, but since I installed
the CDRom in P1-133, I can't boot from the CDRom using

I have a Western Digital 40 gig hdd with Win98 that will not boot to
windows. It will only boot to a command prompt in safe mode.. Efforts to run
scanreg /restore fail because HIMEM.SYS is not loaded.
I need some good ideas on how to transfer files from this drive to a new

The xmonkey tool says it cleaned both disks but I still
get the Invalid Partion Table error when I try to boot
normally.

I recently crashed my PC (it's been awhile since I did) so
I don't want to go through it anymore, ever again...so
someone suggested disk imaging...
What's it all about? And what's the best (easiest) way to

I ran fdisk /MBR trying to get rid of the monkey virus.
Now I get Invalid partition table error at boot. Can I
rebuild with out losing my data? I have a clean boot disk
and I do have EZ drive program.