I have a system running win 98 SE that suffered a major
failure apparently...
After trying to locate multiple folders and files I
checked the scandisk log and noticed it had deleted

Greetings all,
I'm putting together a new PC. The MoBo has 2 IDE channels, and the PC will
have 2 hard drives and 2 optical drives (1 DVD burner, 1 CDRW burner).
What's the best way to configure the IDE channels? Put both HDs together on

I'm trying to download picture and it is appearing upside
down? what am I doing wrong? thank you

Running WIN98, want to upgrade to XP Home.
Drive C: HD too small, so need to replace with generic
Type 47 w/ FAT32.
I do have a ZIP drive installed.

Has Anyone had a problem defragging thier hard drive? I
have a 4gb drive partioned into two drives, C:main drive
and D:system save. The d: drive can defrag fine,but when I
try to defrag the c: drive, it keeps on remapping due to  

Had multiple power outage within a few minutes. (No power
backup).  I knew the HD would be fragged so I attempted
SCANDISK.. 1st time it hung up for over an hour on reading
file allocation tables.  When it finally started.. it

ok i found the article but this doesnt help at all it jsut
describes but doesnt tell us what to do
here it is:
Microsoft Knowledge Base Article - 249824    

We were having serious performance issues with the PC and
I decided to reformat the drive and start over.  All went
well until the CD asked for the code number on the COA.  
All this paperwork (and lots of other stuff) has not been

Does any one know how to rectify this problem?
Thanks

I need files from the 98 S.E. disk after installing an
N.I.C..
I don't have the disks, only Q.R. and enhancement disks.
I searched all disks and drives.

recev'd attach.-zip-file with photos; downld' file and no
photos; numbers and symbols were on file when opend

I just installed a cdrw (MSI CR52-M) to my win98se
presario 5457. I put it on secondary slave. Secondary  
master is the original CD-ROM (with DMA enabled). Primary
master contains a 13gig harddrive with DMA enabled.

I have just attempted to install a new CDRW (Samsung SW
252F) onto my PC running Windows 98SE. It appears to have
installed okay up to the point where I actually try to
access a disk (the Device manager correctly identifies the

How can I tell if I have SE  and should I have it?  How do
you get it?

When I start my computer it's saying Floppy Disc Fail. And
I have to press F1 in order to get in my computer. Can you
please tell me what to do.