Can anyone tell me what the maximum size HDD that W98SE
can format in FAT32 ?  Is it 137GB ?  If so, what happens
if you install a larger HDD (200GB) and try to partition
and format it ?

Due to windows operating system being corrupt, chatted
with a MSN tech.  Recommended uninstalling windows from my
disk & then reinstalling.  Forgot to ask...using Win 98
now.  Should I uninstall & reinstall Win 95 with my disk &

Is there a free utility I can use to do a ScanDisk on my Win98
partition?
I have to run the utility while booted into XP (or DOS) because my
Win98 partition will not laod.

i get a not enough memory when i try to defrag or scan
disk need help i need to do this soon, i just got a new
hard drive maybe this could be the problem i just don't
know enough about computers to know what to do or what to

Like the Subject line says; Windows 98 states my 20GB
hard drive is only 2GB in size.  I have re-formatted and
fdisked the drive, checked the jumpers and even made sure
that my PC's BIOS acknowledges that the drive is 20GB.

This is a continuation of an earlier thread ... concerning lengthy
delays accessing directories on a particular disk drive using Windows
Explorer in Win98SE.
After performing exhaustive tests on the hardware I can now confirm

Hey everyone. I have a Dell Latitude CPt laptop and I
installed Windows 98 on it. Everything's working, but the
display is only about half the screen, and I can  only get
16 colors.  It won't let me make the screen any bigger.

I am unable to install the mobile flash disk on my win98
based computer

on line! do you
know how? here is what the computer says:

I have a Win98SE PC, fitted with 2 hardrives (1 x Primary
Master, 1 x Primary Slave) and a CD-Rom on Secondary
Prinary. This config has been working fine, until suddenly
the D: is not accesable in Windows. Device Manager shows a

Plz write me something about internal process that happns while CD burning.I
monitored through File system filter driver and what i found that for
reading the file it passes through my FSFD but i am not geting any
informtion while writing.

The issue of FAT32 or FAT16..
I have a Gateway GP7 450 pentium III / 10GB..
It has no operating system installed..
Should I use FAT32 or FAT16..

I have two PCs, each with a mobile (i.e. removable) hard-
drive in addition to the normal fixed hard-drive (this is
so that I can swap data between them as they are usually
too far apart to network).

I'm trying to re-format my w98 hard drive by right
clicking the C: drive and clicking format. Once I do this
I get the following message:
Windows cannot format this drive because it contains

I need help please my computer will NOT start windows it
runs through all the processes fine and then when windows
is about to start it gives me this error message.
EXPLORER caused an invailid page fault in module