I've got an older computer that HAD win95 on it and i'm
trying to put win98 on it.I've erased 95 and i get to dos
without any problems but I cant get 98 to boot ,the only
way it will boot is from A or C.Im using a startup disk

Some of my files are corrupted and I need to reinstall
WIN98.  However, I can't get past the DOS prompt level. I
can't even start Windows in safe mode.  Does anybody have
any suggestions how to procede?  All the install and

When installing over 98SE version gone bad, the reboot
brings up the old autoexec and config files.  Aren't these
over-written in the install?  If not, any "clean" versions
on start-up or install disks?

I threw away my product key information and am trying to
recover Win 98 and apps with my Compaq recovery
disks....somebody send me a key, Compaq Help Line is
USELESS!

Downloaded a Microsoft Patch and since then I have been
receiving the following messages on boot up:
1st--- Memory access violation in module kernal32 @
82844:31653243

  I receive the following message when I try to open one
of my programs.  
A required .DLL file, C:\WINDOWS\SYSTEM\IMAGEHLP.DLL, was
not found.

A pal of mine is building thier own pc.  They have a new hard disk
out of the box.  No operating system at all.  They have a win98
install cd.  What else is necessary.  Does she have to have a set of
DOS install disks.  How about formating the hard disk.

I am troubleshooting a shutdown problem in W98SE.
Installed all the supplements, except one alluded to in
K.B. 233036: msconfig\system.ini\386Enh\Paging file= and
then to change the lower case swp file letter to upper

I have a PC that prints results from a program via WordPad.
The problem I have is that it always prints as landscape on USA Letter
format.
I need the default to be portrait on UK A4 paper.

Can anyone tell me what the partition size limit is for win98se?
Thanks

Message; Fault outside of MS-DOS Extender. Windows will
not setup at this message, and microsoft does not have an
answer for it>

I installed openGL95 by accident and now I can;t get past
the login prompt at the end of the windows boot up.
It just stops ...
any ideas out there as to get back to my working state

Win 98 SE.
A friend who actually know less about computers than I do, is having
problems with his computer. (400 mhz AMD) He is not sure when the problem
started but now it does not play normal Windows sounds.

Scandisk has been activated after a series of bad
shutdowns (18month old!). It starts and goes about 22% and
then freezes after reporting a data error while reading
cluster 37399.

Stupid question here,  if i have windows 95 installed on
my computer.  what do i have to do to install windows 98?