I am attempting to install WIN 98SE on a Dell Latitude.  I formatted the HD
and am doing a clean install.  I received the error message SUWIN caused a
General Protection Fault in module USER.EXE at 000B:0094
Any assistance is greatly appreciated.

Given that Win98SE is now End Of Life, are updates (up to the date of EOL)
still available? If I install Win98SE on a new machine, will I be able to
automatically get all the hotfixes (say via Windows update) or will I have
to install them one by one?

I am trying to set up Win98SE as the dual boot OS on a Win2k system.
Currently, Win2k is installed on the primary partition (C:). Will the
Win98SE setup program allow installation on a secondary partition of a disk
or would it have to be on the primary partition (of a second drive ...

Win98se can boot into DOS but not GUI, on either of these 2
mboards.
www.jetway.com.tw/jetway/system/productshow2.asp?id=238&proname=M2GT6%2DPTD
www.jetway.com.tw/jetway/system/productshow2.asp?id=247&proname=M2GT4%2DSOG

Trying to understand the purpose of the following command in my config.sys file (W98SE):
REM: The following two real mode drivers (csmapper & carddrv) allow PCMCIA SRAM cards to be treated as pseudo-floppy disks.
Device=C\windows\system\csmapper.sys
Device=C\windows\system\carddrv ...

Was running 98SE on an old 486 without problems till there was a serious one
that required reformating the drives.  After reinstalling only the 2 HD's
are recognized. My CD doesn't work so I can't install anything.  Should I
try to do it from the registry and what would would I ...

I purchased a desktop that came without an OS. I'm trying to load Windows 98
on it, but it freezes at the "Setting up hardware and finalizing settings"
screen.
HELP!!!

Strange behaviour concerning desktop icons and Explorer window options:
I'm using Win98SE (installed a couple of years ago).
The following strange happenings occurred this morning and I would
welcome any explanations and/or suggestions for how to cure if a reboot

I have an old Compaq Presario PC with Win 98 installed and it just stopped
allowing Windows to run. I've got a Win98 boot disk with CD-ROM support and
the Win98 CD that came with the PC and I can boot with it just fine to a DOS
prompt. but when I try to run SETUP from the CD, it ...

Hello!  I am in need of help.  I have an old laptop that originally came with
Win 98.  I had upgraded it to Win XP.  The system wasn't working well so I
decided to restore the whole laptop to it's original condition via the
Restore CD.  I no longer can find the Win 98 booklet that ...

Failed to register with the Service Provide RTLDI.EXE will terminate
Pls advice what I do for this message coming after booting the computer
regards
raju menon

the cd/dvd-burner fails to burn at full speed...
If I try to burn a cd faster than 16X, then the burner don't get
data in time. The buffer in Nero empties and refills all
the time if the buffer underrun handling is on (default).

Can u give the details & steps of how to install
unattended installation of windows 98. i am searching from
past one week i did't get that, so i am mailing u pls help
me.

Because I need to use some peripherals that won't work with Win XP
(e.g., no drivers), I need to try to reinstall Windows 98SE to a
machine which had a HD failure. (AMD Athlon 1.8 mhz, 512 mb RAM, 120 gb
HD)