'ello 'ello
I was trying to use my 'startup disk' to run a neat little utility called
delindex ....   alas, I have discovered that the system cannot read any of
my floppies. Get err message "general failure reading drive a"

Just installed ME clean on new hard drive (western digital)
but it's only showing 2 gb instead of 40 GB.  New
motherboard so I don't think BIOS is problem.  Any ideas?
Thanks.

I pulled out both of my hard drives from my old p3
running windows me in order to put my 40gb into my newer
system. When i put the original 6.4 back in and rebooted
i get the messages "detecting primary master-none" and

A little while ago my hard drive crashed. I replaced it
with a western digital (WD1600) drive. I loaded ME from
the recovery disks into the clean drive. When the system
comes up, the bios shows 149 gig. However, my computer and

I am having serious trouble defragmenting and scandisking
my hard disk. In paticular, My "C" partition of the hard
disk will NOT even start up(hangs up)as it will only
say "reading contents...." and the same said for scandisk.

Windows Me recognizes my cd drive as a local disk just as
it does my C drive. I can't access my cd drive.
Please help!

I have upgraded my computer from a PIII 500 Mhz with 256Mb
of Ram to:
-New Motherboard Asus P4P800
-A 2.8E 1MB L2 cache Intel P4

I am reinstalling Windows ME from my recovery CD, and when
the installer is halfway, a GPF occurs.
I am sorry I cannot be more precise, but I need to restart
Windows ME setup to reproduce this error.

Everytime I start Internet Explorer I get many popups like
screensaver.com or americansingles.com and it is driving
me nuts. Also, after about 15 minutes, the computer starts
to get slower and slower and in the end it freezes and

I am using a Packard Bell with a 17.2 GB Hard disk running
ME
I went through all the eapplications and the recycle bin
to clear hem.

Every time the computer starts up after being either
shutdown or rebooted, there is no power going to the
netgear USB wireless adapter. Upon removing and
reconnecting the device it powers up and resumes connection

My computer won't shut down when I use the start shut down
button. It just goes to a blank screen... can anyone tell
me what I might try to fix this problem? This happens all
the time...

I installed new 3Gig P4 & motherboard with 2 512 MB memory
chips in dual channel mode. Since I am getting the out of
memory message, I know from above article that I must
limit my Windows Me memory by using MaxFileCache=512MB OR

Good morning:
ScanDisk is reporting inaccurate free space on my hard
drive.
It's a 20 GB hard drive on a Compaq Presario 5000

When booting Compaq PC recognizes new hardware.  None
installed, and cannot find drivers.  When canceling out
receive the following
ENUM\HTREE\ROOT\0 then SUREGCREATEKEY FAILED.