I connect to a network service provider using wirelss, pay the required fee,
but when I try to access my emails or browser I get the message "Limited or
no Connectivity". Signal strength is "good" or "excellent".  I have been told
there is a patch to correct this. Does anyone ...

Help...
i have a 2 wireless computers and one that is wired to the wireless/wire
router.
i want to network all three.

I’m looking help for a way to have XP only connect to my wireless access point.
I do not want the user to have the ability to see other available wireless
networks and more importantly I don’t want them to have the ability to
connect to wireless networks other than the one I ...

I have been using 802.11b since I went broadband. I later upgraded to
802.11g. After being up and running, rather well I started dropping the
signal on the notebooks. I changed my phone to a 5.8 Ghz, raised the router
and of course changed channels. Their was no cure, I used tech ...

I am close to getting a wireless setup on my home computers but I am
having fluctuating signals on the wireless system.
The first computer is connected direct to the router and then to the
DSL line. It is a full time connection, not PPPOE connection.

Is there a way that I can get my wireless connection to automatically enable
when I unplug my wired connection?
Or, if both are enabled at the same time, which one does my laptop use?
Obviously my wired connection is faster, so I would want it to be the default.

Please help I have a PC and 2 wireless notebooks, the wireless note books
allow information transfer and access to each other, but my main PC with
printer attached will not allow me access, and says contact your network
administrator which is me. How do I get all 3 computers to ...

In my Windows XP, WPA-PSK protected home wireless LAN (via router > cable
LAN) one laptop was having problems regaining internet access after
hibernating. I solved the problem by switching it's wireless TCP/IP setting
from

I'm searching for a wireless card pci for a pentium 3 with normal PCI slot
(not a modern pci),  i a industrial media.
I would like this card support a, b&g mode.
I've tried products like dlink (air plus xtreme G+ - dwl520+) but that work

When using the windows utility with my NetGear WiFI Ma401 PCMCIA Adapter
Card and when I want to write the network password, I receive a message
saying "The network password must be 40 bits or 104 bits according to your
network configuration... " and I am not able to connect.

We have a CISCO wireless access point connected to our wired network. I
keep getting asked what happens both the Local Area Connection and
Wireless Network Connection are enabled. What does happen? Which one is
connected? Are they both connected? Does one override the other? Thx.

Whenever i turn on my laptop i always have to enable the zero wireless
configuration service in services, i have tried to automatically start the
service but when i come to turn on my laptop again i have to go into services
and do it all over again.

I've had a Linksys WRT54GS router working well for some time. I decided
to extend the range in my house by adding a WAP (WAP54G?). Seemed
straightforward. Assign it the same SSID as my router and i could
seamlessly move between the two - correct? Not working. I have the WAP

XP Pro
IBM Thinkpad T41p
Wireless card Intel Pro/Wireless LAN 2100 3B Mini PCI Adaptor
A client is using this and his wireless button is turning itself off every 5

Recently, when I have to repair my net work connection (which I have to do
periodically), it renews the IP address and all but then says that Windows
could not finish repairing the problem because it the following action cannot
be completed: Clearing the ARP cache. Everything ...