I have a WRT300N V2.0 that works like it should against the internet. I
have two computers connected by wireless to this router. They are
assigned ip-addresses 192.168.1.102 and 192.168.1.105. Both can reach
the internet.

can anyone help i dont no much about networking. i got a belkin router and
wanted to set up a wireless network with my pc with a printer connected to it
and a lap top. i ran the wireless connection wizzard it told me to plug in a
flash drive  in to my pc then the router then the ...

Help please this is driving me nuts...
I have a netgear DG834 firewall modem that is connected by ethernet to my
main home pc, I have recently connected to this router a netgear wireless
router WGR614 plugged into a port on the DG834 and my laptop is wirelessly

Hi- for the last 3 days, I havent been able to connect through my laptop,
even though my Qwest dsl modem box is 3 feet away. It was working great til
3 days ago. I actually suspected a problem when I went to my sisters house
w/my laptop (who has wireless enabled too) & tried to ...

I have 8 computers (win2k & XP) networked with a wired router. I need to take
them into an office where there is internet access by a wireless network. I
can't get a wire from the existing wireless router to the place I need to set
up my network. Can I use a wireless router to ...

i continue to receive this error.  i can connect wirelessly with third party
connection management software such as boingo and config utility that came
with my adapter card, but whenever i try to connect with windows utility i
get the same error.  even in the system tray it says ...

I have a desktop and a wireless laptop the problem is I cannot connect to
the internet on my laptop.  My friend has a sony and you can turn on the
wireless with a switch on the outside mine does not have one.    I have
broadcom wireless utility and when trying to enable states ...

I have sucessfully hooked my wirless laptop to my network printer (HP) and
it works fine but once I turn the computer off and turn back on the I get a
message
"Printer Properties cannot be displayed. The print spooler service is not

Newbee question.  I have read one should disconnect from the Internet when
not using it.  Is this only for people who leave their computers on
permanently.  Surely if you switch off your PC then someone from outside
can't get into your system via your phone line router ...

We are using a Linksys WAP54G as a WAP.
To enter the web interface, there doesn't seem to be a way to specify a
username - it is blank - although you can set the password.
I'm sure it's very simple, but does anyone know how to set a username?!

I am new so excuse if any mistakes.  I have a gateway wireless notebook
with a 802.11 g wireless it is a broadcom wirless network utility the problem
is I have dsl with wireless access and cannot connect what so ever.  I have a
friend with a sony notebook and can turn on and off ...

Any explanations available? If my WLAN switch is enabled and the Wireless
Access Point is ON, my notebook boots up in 60 seconds. If either of them is
OFF then my notebook takes 3 minutes to boot up. Why?
The notebook is a Compaq presario V5000 (with XP Pro SP2 and all current

Just to clarify, I'm not talking about setting an encryption key--I'm talking
about setting a password for the setup/configuration software that comes with
a gateway or wireless AP.  i.e.  I read the following in a book dealing with
home networks.

I thought I throw this question for an advice. We're just about to
implement our wireless solution. After reading numerous technical
documentation cover to cover, it came down to the below questions.
Scope:

My setup is as follows
1) Router - 2WIRE
2) PC Desktop with D-link G132 USB Adapter with XP Pro SP1
3) Macbook