well, i intstalled my driver just fine and good but i get this low quality
sound, very very low... like no bass etc
so how?
p/s:i use Avance AC97

windows xp - when i put in a new rw-cd ti copy i get a
message that says " no disk in drive " brand new in cd-rw is in slot --when
i check properties , i get" o spac used" --"o space aviliable" yet out of a
5 pack of new disks 1 did work and was able to write to it. Is ther any one

Does Microsoft Windows XP Professional 64-Bit edtion support true 64-Bit processing (i.e. utilizing the full 64-bit CPU registers for computiations) in hardware as avaialable with the AMD Athlon64 and Opteron processors?
Or (as alleged by Intel to me over the phone) not a true ...

Hello............I recently removed an internal DSL modem I no longer needed
to free up a PCI slot. I have an installed USB 2.0 PCI card that I wanted to
move to a different slot. Will XP (HE) see this as a new card and want me
re-install drivers, or will it just see it for what ...

I am using MSN Messenger 6.2.0205 on Win XP Pro desktop. I have
installed and have running the MS Fingerprint Reader. I am having
problems setting up the MSN Logon information.
Whenever I try to set up MSN Messenger logon, I receive message "Your

I have a problem with several USB mass storage devices (ipod, external
harddisk, thumb drives aso) They are all recognized by xp and starts ok, but
after a while they disappear just to get started again.
Can anyone please help?

Hi folks - I hope this is the most suitable forum for this question.
I have a very small but incredibly annoying problem with my hardware setup
(arent they all?).
About three months ago, I bought a new 17" TFT monitor to hook up to my

I have a soyo k7vem-pro mobo that is apparently on its way out. I want
to replace it without losing all the custom settings and installed
apps, etc on this computer. ( I use this machine for music recording
and have tons of tweaks to win xp, services turned off, everything

Asking this as when I downloaded a prog to install a Packard Bell 1015
monitor driver for XP (see other post), it stated 'cannot run on NT'
when I tried to run it. I have XP Pro. Any ideas?
BTW the file was Mondrvupd20.exe supposed to cover lots of PB drivers

My son reports that he has installed a Hauppauge PVR-150 and also tested
installing a PVR-500 in his Dell P4 system (I do not have the specs at hand
but it is about 1 year old, top of the Dell line when purchased).  He is
running XP Home, fully up to date.

Whenever I plug in my speakers Windows XP installs a "C-Media AC97 Audio
Device." I then get an error that says "the device was not installed properly
and may not work correctly," which of course it doesn't. I even went out and
bought new speakers and still end up with the same ...

While installing a driver for a new graphics card (Asus A9250 Ati Radeon) the
message 'An error occurred during the installation of this device. Access is
denied' appears at the end of the installation. Through searching the
internet I have found other people with similar ...

I have a friend who had a corrupted windows file but couldn't resolv
the issue and ended up reloading Win XP.  After doing so, he discovere
that none of his programs will execute now.  When looking under "start"
"programs", it no longer displays the programs.  But, the progra

Can one replace a second floppy drive with a zip drive?

I recently disabled the parallel port in the BIOS (I wasn't using it
anyway) to try and free up an IRQ or some system resources, when I installed
a firewire controller (which I wanted to have its own IRQ if possible).
Then I periodically started getting this error "The Parallel ...