I upgraded my computer. I need to know " how to get programs to import or
work from my orginal hard drive to work on a new hard drive in windows xp
without doing a disk image?

I recently bought Adaptec 2400A IDE RAID Controller, and I have
troubles with it. I saw that many users written on Internet about
this, but i did not seen any solution that is why i am asking.
I have very low transfer speeds form RAID it is about (25 MB/s). I

Does anyone know if APC Back-UPS CS have any XP native driver?
This is the unit I am looking to buy:

I have a Sony handycam model HC 40 E.My desktop is fitted with IEEE
1394 card.The camera is detected immediately and the video capturing
starts when I coneect the camera with a cable of 4 pin(camera end) - 6
pin(computer end).

I  have purchased 3 usb mass storage devices this year.  60gb and 80 gb WD
usb protables and a simpleTech 8gb Mini Drive.  I run like 130 computers and
the idea was to keep my softweare on there so I would not have to use disks
for most stuff.  It worked great for a little while, ...

My cd-rom will not open to insert a cd..by checking event propeties, I see an
error msg of cdrom0 has a bad block..what can I do about that?

Although this is not a Vista newsgroup, I thought I'd ask this question
anyway.
Vista will be for both 32 bit and 64 bit processors.
how to I change from 32 bit to 64 bit processor.

Recently on my pc, which is only a year old, Windows would begin to start up
but would freeze or hang, whichever is correct, with the moving blue
rectangles ceasing to move, and nothing happening until I switched off the pc
and re-started in safe mode, which usually or perhaps ...

I defragged my hard drives and lost access to my second drive which contains
my files which I haven't backed-up in six months. My operating system and
programs on drive 0 still work. When I try to access drive 1, I get a message
that says the drive is not formatted. How can I ...

My DVD mechanic doesn´t work.It write error ,,code 41´´.What shall I do with
it?
Tkanks for answer.

 I'm running WinXPpro+sp2. My sole internal hard drive failed; with
repeated applications of chkdsk, I was able to regain a limited dos-view
of the entire disk (via the "r" option when you boot winXP from the
original install disc).

A couple of months ago I had problems with my computer. One thing that
occurred was the setting in my BIOS that requires a password to access
the settings was changed to enabled during a system failure. (Why this
occurred

I have installed a radio scanner and software to operate it via my 9 pin
serial connection. I set the baud rate on the device and it should be
communicating with the computer. In device mgr. on com port 3 I get the
following msg.:

Please help.
I have just tried to put a SD memory card in my card reader to find that the
normal window that appears to allow you to view photos etc did not appear.
The green light on the card reader did come on, though. I checked on my

I have xp sp2.  I was installing a program that would virtually let me
try out linux installations while still in Windows.  Halfway through
the installation, my computer shut off and now my usb ports no longer
work.  I get code 39 ("Windows cannot load the device driver for this